When decorating the bathroom, the installation of wall and floor tiles, ceiling treatment, pipe installation and equipment selection should all be considered for waterproof and moisture-proof requirements, and careful arrangements should be made. When paving walls and stones, the waterproof layer should be made under the surface layer. The cement mortar should be used to level the ground and coated with waterproof coating. Then, a layer of 1 to 2 cement mortar is used as a bonding layer to spread the floor tiles and other decorative materials. After watering, use a wooden board to make it flat and firm, and the seams are tight. Before the stone is laid, the back coating should be done to reduce the phenomenon of “water stainâ€. The area around the waterproof layer should be turned upside down, about 25 to 30 cm above the ground, the washstand should be 1.0 to 1.2 m above the ground, and the shower should be 1.8 m above the ground. If the paint is decorated, it should be brushed with waterproof putty and waterproof coating. The surface layer of water should be treated to slope to the ground, no flooding, no water accumulation, no leakage after 24 hours storage test. Suspended ceilings are recommended with micro-aluminum gussets to enhance ventilation and prevent condensation. If you want to make gypsum board ceiling, you should first brush waterproof putty, then brush waterproof coating; PVC ceiling is easy to produce condensed water, and drop, should be used with caution. Pipe installation should try to avoid changing the original upper and lower tubes. It must be horizontal and vertical, and laid firmly, and the slope should meet the requirements. The valve and the faucet are installed in a straight, flexible and convenient manner, the anti-rust paint is applied to the bright tube, and the anti-corrosive paint is applied to the dark tube. The water supply pipe is tightly connected with accessories and appliances, and there is no leakage through the water test. The floor drain design is still based on the above sewer line, and the surface should be slightly lower than the ground. The sanitary fixtures are installed in the correct position and the upper edge of the appliance is level. Bathroom appliances should be branded and have good waterproof performance. For example, the shower heater should be used in a humid environment for a long time. The outer casing should be made of stainless steel. It has good anti-corrosion performance, and it is equipped with waterproof power switch, cable and plug. Or when the power is off, you are not afraid of water and water splashing, and will not cause leakage or damage. Also need to be equipped with a waterproof lamp cover, waterproof socket and so on. In the bathroom should avoid the use of wooden materials, if you need to use, you should use fireproof board or full oil decoration, can be waterproof. When making ceilings or other package decoration, the hidden wooden keel needs to be painted with waterproof coating or preservative.
Silicon Carbide Abrasive Paper can used for wood polishing and metal polishing. Some of it can used for anti-clogging Abrasive Paper. It has the good effect of anti clogging. Some of the abrasive paper can do waterproof and oil proof. The shape of the abrasive paper can made into roll and sheet.
If you have any questions, please contact with us directly. The Abrasive Cloth are produced with high quality and good appearance. Welcome you can visit our factory for inquiry. Please send mail directly to us.
Silicon Carbide Abrasive Paper Silicon Carbide Abrasive Paper,Soft Sand Paper,Matel Grinding Emery Paper,Silicon Carbide Paper Jiangsu Fengmang Compound Material Science & Tech Group CO.,LTD , http://www.fmabrasive.com