Acceptance material Abstract: Plumbing and fittings entered the site, and the owners and decoration workers accepted the inspection. Pay attention to check whether the water pipe is genuine. According to the size of the mouth, the distance between hot and cold water pipes is determined. The diameter of the mouth is generally 8cm. Use a pencil to set the position of the upper and lower metal tube clamps. The diagonal between the two points is approximately at a 45-degree angle. Use an electric hammer to drill at the anchoring point. The upper part of the distribution box cannot be opened because of the wires. Otherwise, electric shock may occur. Nail wood wedge After nailing the wooden wedge in the hole, screw the metal pipe clamp on the wooden wedge again. Be sure to screw the screws firmly into the wooden wedge to prevent loosening. Measure the length of each section of the required water pipe with a tape measure. In general, the width of a wall is the length of a segmented water pipe. Wall drilling Hydropower renovation entrance decoration restaurant interior decoration
According to the facilities for the living room, arrange water pipes. Then slotted in the wall, put the upper pipe buried in the wall plastering, outside the tile. Hot and cold water holes in the wash basin at a distance of ten centimeters, left hot right cold; hot and cold water holes in the shower is generally fifteen centimeters, left hot right cold. Washing machines, etc. do not need hot water holes. 
Love Kang hose 
Love Kang hose
1 2 Next> Total 2 Page
Page to page