Powder Actuated Fastening System Accessories include the Power Loads and nails for powder tools. Powder Actuated Fastening System Accessories Powder Actuated Fastening Accessories,Powder Actuated Nailer,Powder Actuated Nail Gun,Powder Actuated Hammer Yibin Heheng Technology Co.,Ltd , https://www.actuated.nl
The reasonable choice of sealing screw depends on the size of the project. We recommend a reasonable selection of the use structure of the sealing screw. If the project is not large, you can use the traditional sealing screw; if the project area is more than we must use the new sealing screw, due to the new type The water screw outer rod and the joint nut can be recycled. Compared with the advantages of the new water screw, it brings not only a little bit of convenience to the project, but also the most important thing is to save money. In fact, the use of water stop screw in order to eliminate the risk of violence in the concrete pouring process, as well as to post-construction wall with water stoppage, waterproof effect. In the early stages, the problems that arise in the purchase and use of the water stop screw must be eliminated and the hidden dangers in the wall should be reduced to zero.
The use of water stop screw specifications The use of traditional water stop screw specifications and the use of new water stop screw specifications have a difference in length, the first material of the water stop screw using the same diameter, follow the wall below 5 meters using a diameter of 12MM The length of the water stop screw is cut due to the old waterstop screw, so the length of the traditional water stop screw is the length of the entire screw, that is, the width of the wall plus 40 centimeters. The waste and pollution caused by each cut is very serious. The new water-stop screw because of its own structure for the three sections, the outer rod and the joint nut can be reused, the use of the length is the width of the wall minus a horn head height. From this point of view, the new water-stop screw is very economical and environmentally friendly and can be widely used in the construction industry.
Water stop screw structure classification Water stop screw is divided into one section and three sections. The traditional water stop screw must be operated strictly in accordance with the requirements during the construction process, and it should be installed and used in an orderly and progressive manner. This can reduce the wall caused by construction reasons. The loosening of the screw in the body also effectively improves the cutting efficiency, so as to guarantee the effectiveness of the sealing and waterproofing of the subsequent wall. In addition, due to the cutting of the wall after the construction of the traditional sealing screw, the appearance of the wall will be reduced. It is recommended that you use the new sealing screw, which not only saves the complicated operation procedures, but also reduces the cost and reduces the construction cost.