Many people think that after buying a second-hand house, just spend some money to renovate the house, which is almost the same as the new one. However, if you choose an older house with a longer house age, special attention should be paid to house decoration so as not to cause many problems in future life. A friend who bought a second-hand house nearby was not very familiar with the structure and material of the house he purchased, resulting in a phenomenon such as wall cracking less than a year after the renovation. In order to avoid the emergence of these problems, let us take a look at what problems should be paid attention to the decoration of second-hand housing it! >>> 1, for the toilet closed water test Before decorating a second-hand house, first of all, the decoration worker should be asked to perform a water-removal test for the restroom, and check how the previous water-repellent treatment is done. The method is: block the Floor Drain, put 5CM of water in the toilet, observe for 24 hours, and then go to the neighbors downstairs to check, if there is no leakage, prove that the waterproof treatment is done well; if it leaks, we must ask the property to re-waterproof After finishing the waterproof treatment, wait until the ground is completely dry and then paste the tiles, otherwise the ground will crack. 2, water, circuit transformation processing After all the waterway transformations have been completed, it is necessary to make the pipelines reasonable, connect tightly, run without leakage, and move without violation. As for the transformation of the circuit, if the old house is made of aluminum wire, it must be demolished. Modern home appliances are many. According to national standards, 2.5 mm copper wire must be used in the decoration, and the circuit for installing high-power electrical appliances such as air conditioners should be separate. Take a 4mm2 line all the way. PVC insulated pipe must be used when embedding in the wall. 3, paint the wall, the bottom is the key The walls of the old house will be cracked and peeled. Therefore, when decorating the wall, be sure to pay attention to the basic treatment. Generally, a good decoration company will apply the interface agent and interface agent after leveling the wall. With the role of moisture, but also can play a role in the protection of latex paint, followed by putty, putty paste to use waterproof putty, putty scraping generally have to be three times, and finally brush latex paint. If the wall is to be colored, paint it accordingly. 4, replace aluminum or steel doors and windows Wooden doors and windows, if there is no deformation or cracking, indicating that the material is very good, can be decorated in the decoration, affixed to the veneer plate, and then painted with paint, continue to use; if the wooden doors and windows have been deformed, then it will be demolished, re-production. Iron doors and windows, if the surface of the paint has been peeled off or the main body cracking, it is recommended that everyone remove, replaced by aluminum or plastic material. Because the doors and windows of these two materials can play a role in sealing, sound insulation and heat insulation. 5, increase the essential switch and socket Nowadays, as more and more appliances are used in homes, lighting and lighting equipment are becoming more and more colorful, so there are many places where switches and sockets need to be placed. Well, before the renovation, we must do a good job of wiring in advance, which places need to be placed in the future, to do a good job in advance planning, and the old house reserved switches and sockets are generally not enough. In general, a room must have at least 3 outlets. There should be no fewer than 15 sockets in a two-bedroom residential building and no less than 8 switches. The switch height of the same room should be the same, the general switch is 1.4 meters from the ground, and the outlet is 0.3 meters from the ground. The switch between the suspension and the living room should be set in a place easily accessible to the owner. 6. Do a good job of disinfection to maintain indoor air circulation During the entire process of renovation, especially after applying glue and brushing paint, it is necessary to open the window diligently to keep the air in the room. If there is no window in the bathroom, open the exhaust fan. The decoration process should be thoroughly disinfected on a regular basis, and can be sprayed with 3% lyosol, 1%-3% bleach water, or 3% peroxy acetic acid solution. Close doors and windows for 1 hour after spraying. In addition, it is recommended that you do not immediately stay after the renovation, if the conditions permit, it is best to open the windows every day, to maintain indoor ventilation, can make formaldehyde and other toxic gases quickly evaporate. It is advisable that the room be completely ventilated after 3-6 months. Of course, each family's situation is not the same, but these aspects of the above are to be considered when renovating second-hand housing. Hopefully, those who want to decorate second-hand housing can help. Second-hand house window switch paint socket house decoration living room wall color decoration living room bathroom tile color bathroom waterproof bathroom tile bathroom door bathroom leaking tile adhesive
Toilet Flush Valve
Pedal Toilet flush valve is a kind of commercial faucets, widespread use in public toilet, like hospital, station, restaurant, school etc. It made of brass and chrome finished. In-let water size G3/4" or G1", out-let water size G1". The working pressure of the product is 0.05MPa to 0.9MPa. Working temperature is more than 0°
Manual Toilet Flush Valve,Foot-Pedal Toilet Flush Valve,Automatic Toilet Flush Valve,Public Toilet Flush Valves SHENZHEN KING OF SUN INDUSTRY CO.,LTD , https://www.handybasinfaucet.com