Ready to install the tools, check whether the complete set of accessories before installation, common leading parts and accessories are: hose, rubber gasket, shower, go to water, kidnapper, decorative caps and so on. 1, single hole basin faucet installation When buying single-handle basin faucet, you should pay attention to the outlet diameter. Now most of the market is a hard-tube inlet, so you should pay attention to the height of the reserved inlet, the most appropriate from the basin downward 35 points. When installing, it must be equipped with a special angle valve, and the angle valve must be fixed with the hot and cold water pipes of the wall outlet. When you find a distance between the angle valve and the faucet hose, buy a special extension tube to connect. Remember, do not use other pipes to connect, because if the water pressure is high, it is easy to fall off, leak, and cause losses to you. If the inlet pipe is longer than the outlet pipe, you can cut it off according to your needs. If the angle is not appropriate, you can bend it to your desired position. Remember: Do not bend hard to 90 degrees or more than 90 degrees. When installing the basin to remove water, do not forget to purchase the faucet's small connector (short for the faucet). Don't forget to flush the water pipe buried in the wall before you install it. 2. Installation of Shower and Bathtub Faucet (wall-mounted) When you have purchased showers, bathtubs, wall taps, you can choose the appropriate height to bury the water pipe. Hot and cold water pipes must be spaced 15 cm apart. Before installation, you must not forget to flush the water pipe to avoid excessive water quality and damage the mixer. Concealed shower, bath faucet: After purchasing a concealed faucet, it is generally necessary to embed the valve plug of the faucet in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the valve plug cannot be embedded. The plastic protection cover of the valve plug should not be easily removed when it is embedded, so as to prevent the cement and other chores from damaging the valve plug when it is embedded. In addition, when embedding the valve core, it should also pay attention to the direction of the valve core up and down, left and right, so as not to miss the valve core. Wall mounted faucets are pre-installed into the water pipe with dimensional deviations that can be adjusted using the available adjustments. 3, the installation of thermostatic faucet Before installing the thermostat, please check whether the water pipe is hot or cold. Remember not to connect the hot and cold water pipes incorrectly to prevent the faucet from working properly. Gas and solar water heaters cannot use thermostats because the water pressure is too low. Do not forget to install the hot and cold water filter when installing the thermostat. 4, single hole kitchen faucet installation The requirement is stable, because the kitchen mixer is used frequently, and it is easy to loosen and move it. Therefore, the lock nut must be tightened. At present, there are some faucets on the market that use nuts to fasten the nuts. This kind of stability is very good. If you can solve the problems of removing water, it will be a popular trend in the future. Decoration process bathtub water heater brand solar water heater cement decoration bathroom size bathroom leak 
Green Sun Faucet