Alloy Steel Pipe,Alloy 20 Pipe,Seamless Alloy Steel Pipe ,Alloy Steel Seamless Pipe Liaocheng Xinglong Seamless Tube Manufacturing Co., Ltd. , https://www.lcxlpipe.com
1. Regular waxing, about once every 1-2 months.
The bottom layer of PVC coil flooring in the domestic market is mainly non-woven fabric and glass mat. Since most of the bottom layer is a porous material, it is firmly bonded when adhered with an adhesive. However, since the dimensional stability of the pvc material of the underlying material and the surface layer is different, the surface layer generally shrinks with time, so the two sides tend to warp upwards and are easily broken. Therefore, the joint should be firmly attached. Jiuzhi Plastics Network reminds you to pay attention to the maintenance and maintenance of plastic flooring in daily life. Only in this way can you maintain its beauty and extend its service life for a long time. Please pay attention to the following 8 points:
2. Avoid using a lot of water to mop the ground, especially to avoid contact between hot water and alkaline water and plastic ground, so as not to affect the bonding strength or cause discoloration and warping.
3. Sharp metal tools such as cookware, knives, scissors, etc. should be avoided on plastic floors, and sharp metal objects should not be used on plastic floors to avoid damage to the floor surface.
4. If the floor is stained with ink, food, oil, etc., wipe off the dirt first, then wipe it off with soapy water diluted with cloth. If it is still not clean, gently wipe it with a small amount of gasoline until the traces disappear.
5. Do not place hot objects above 60 °C on the plastic floor and step on the cigarette holders to avoid deformation and scorch marks on the plastic floor.
6. In the concentrated load concentration area, a larger area of ​​the block should be padded to avoid permanent deformation of the floor.
7. Where it is often exposed to direct sunlight, it is best to hang curtains or bamboo curtains to avoid fading of the floor.
8. When the plastic floor is seriously damaged, it should be replaced in time; for the degumming part, it should be cleaned first, and then re-applied with the original adhesive. It can be used normally after 24 hours of maintenance.
Jiuzhi Plastics Network